›

Need help with Repetier software

flyfastflyfast
in Repetier-Host
I just finished building my 3D printer (Prusa i3), and was planning on using the Repetier software.  I was able to launch an initial scan, but, didn't get too far into it.  Well, now when I load an STL file and attempt to run the printing job, it opens up the 'manual' tab and I get a message that says 'print job finished'.  

Thus I am unable to print anything.  Can anyone help me with this?  It would be much appreciated! 

In case it is needed, I am running version 1.0.6 of the software.

Comments

  • RepetierRepetier
    Sounds like you have forgotten to slice the model first, Then the print script is rather short and finishes immeadiately.
    Do not forget to configure slicer first!
Sign In or Register to comment.