#define DEFAULT_MINSEGMENTTIME        20000

I see#define NUM_EXTRUDER 1 so that is correct in config.h

I have my extruder fan plugged into D9 on my Ramps 1.4 board, in the Repetier firmware #define FAN_BOARD_PIN was at -1 as well as in Pins.h as per default. The red light which indicates the fan is on

Bed slam, betcha saw that coming #define Z_PROBE_ON_HIGH false change to false and G32 s0 probes my 3 points five times and seems to work 

#define ENDSTOP_PULLUP_Z_MIN false

1. Z-min is false (I found that info in another post) [discovered software endstops as well, A+ feature i like it] 2. The Z-probe pin is set to #define Z_PROBE_PIN ORIG_Z_MIN_PIN which i would assume

#define Z_PROBE_HEIGHT 1

#define ENDSTOP_PULLUP_X_MIN true

#define THERMOCOUPLE_0_PIN  2   // Dua analog pin #59 = A5 -> AD 2

#define Z_PROBE_X_OFFSET ?

#define FEATURE_Z_PROBE 1

#define EXT0_HEATER_PIN HEATER_0_PIN

#define ENDSTOP_Z_BACK_ON_HOME 10

#define DISTORTION_CORRECTION         0

#define ENDSTOP_PULLUP_Z_MIN false

#define EXT0_DECOUPLE_TEST_PERIOD 0

My current config for the firmware is #define FEATURE_AUTOLEVEL 1

* #define ENDSTOP_PULLUP_X_MIN true

I followed the steps given from this site: #define FEATURE_Z_PROBE true

#define RETRACT_DURING_HEATUP true