-
RepRapD1scount Smart Controller
by silver1882 ·#endif -
Laser with inverted signal
by kvbilek ·#endif -
Mirrored Extruder spins with Z on Home and Raise
by RandalZimmer ·#endif -
PanelDue Sd-card
by Repetier ·#endif -
Cable Robot using Repetier
by Jagi ·#endif -
Z axis not moving at all on COREXY
by Bleachworthy ·#endif -
1.0.4dev homing problems -CR10S (Crealty 2.1 board)
by badvision ·#endif -
Afinibot A3 upgrade problems
by jonarotz ·#endif -
Linear advance extruder stops
by overdrive ·-1 //#define SDCARDDETECTINVERTED 0 //#endif #define SD_EXTENDED_DIR 1 /** Show extended directory including file length. Don't use this with Pronterface! */ #define SD_RUN_ON_STOP "" -
Firmware 1.0.4dev not compiling
by Repetier ·#endif -
No voltage output on D10 pin while G1/G2/G3 command in laser mode
by rdzawka ·#endif -
Print randomly pausing at retract
by opy01 ·#endif -
Dual X carriage printer - cooling fan
by Repetier ·#endif -
BLTouch not working
by neoh ·#endif -
Printing a Dot in Lasermode
by RAyWB ·#endif -
Z probe height
by The_Geak ·#endif -
Problem with Z axis
by Dave_Da48 ·#endif -
MABL mit BL Touch
by Bonobo ·#endif -
Problem using 3 Z steppers and bed leveling
by bryanbdp ·#endif -
Add reversing motor direction flag for mirrored axis steppers in next Release (MPCNC and similar)
by LucidWolf ·WRITE(X2_DIR_PIN,INVERT_X_DIR);#endif } else { WRITE(X_DIR_PIN,INVERT_X_DIR);#if FEATURE_TWO_XSTEPPER || DUAL_X_AXIS WRITE(X2_DIR_PIN,!INVERT_X_DI