#define Z_PROBE_Z_OFFSET 0

#define X_MAX_LENGTH 250 #define Y_MAX_LENGTH 250 #define Z_MAX_LENGTH 250 But it doesn't seem like that when I move my axis...!It's like it consider it 90 x 90 x 90! Could it be something regis

...... some config from configuration.h #define DISTORTION_CORRECTION 1 #define DISTORTION_CORRECTION_POINTS 5 #define DISTORTION_LIMIT_TO 0 #define DISTORTION_CORRECTION_R 60 #define DIST

#define NUM_HEATERS 2

#define SD_RUN_ON_STOP "G28"

#define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_X 500 #define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Y 500 #define MAX_ACCELERATION_UNITS_PER_SQ_SECOND_Z 500 #define MAX_TRAVEL_ACCELERATION_UNITS_PER_SQ

*/ #ifndef CONFIGURATION_H #define CONFIGURATION_H #define NUM_EXTRUDER 1 #define MOTHERBOARD 402 #define RFSERIAL Serial #include "pins.h" // ################## EDIT THESE SETT

#define STEPPER_INACTIVE_TIME 360L

#define RX_BUFFER_SIZE 128

//#define RX_BUFFER_SIZE 1024

//#define RX_BUFFER_SIZE 1024

#define FEATURE_TWO_YSTEPPER 1 #define Y2_STEP_PIN ORIG_E1_STEP_PIN #define Y2_DIR_PIN ORIG_E1_DIR_PIN #define Y2_ENABLE_PIN ORIG_E1_ENABLE_PIN #define FEATURE_TWO_ZSTEPPER 1 #define Z2_STEP

Regards. RH; */ #ifndef CONFIGURATION_H #define CONFIGURATION_H /**************** READ FIRST ************************ This configuration file was created with the configuration tool.

#define FEATURE_TWO_YSTEPPER 1 #define Y2_STEP_PIN ORIG_Y_STEP_PIN #define Y2_DIR_PIN ORIG_Y_DIR_PIN #define Y2_ENABLE_PIN ORIG_Y_ENABLE_PIN #define FEATURE_TWO_ZSTEPPER 1 #define Z2_STEP_PI

This is all what I did:*/ #ifndef CONFIGURATION_H #define CONFIGURATION_H #define NUM_EXTRUDER 1 #define MOTHERBOARD 402 #define RFSERIAL Serial #include "pins.h" // ###########

*/ #ifndef CONFIGURATION_H #define CONFIGURATION_H /**************** READ FIRST ************************ This configuration file was created with the configuration tool. For that

#ifndef CONFIGURATION_H #define CONFIGURATION_H /**************** READ FIRST ************************ This configuration file was created with the configuration tool. For that reason, it

#define X_ENABLE_ON 1

  #define LEFT_PROBE_BED_POSITION 20

#define CONFIGURATION_H