#define Z_PROBE_BED_DISTANCE 1.99      <<<set this to 5, distance to raise Z between probe points

 #define  _WRITE(IO, v)   do { if (v) {DIO ##  IO ## _WPORT |= MASK(DIO ## IO ## _PIN); } else {DIO ##  IO ## _WPORT &= ~MASK(DIO ## IO ## _PIN); }; } while (0)

#define Z_PROBE_X1 15   ;<< change this to 70 to allow for probe X offset, so probe is not right at the edge ob the bed

#define Z_PROBE_Z_OFFSET 0

Well, I couldnt stop thinking about this and I ended up remembering that I have "MOTHERBOARD == 63". So I checked the pins.h file and found a "#define SDSUPPORT 1  // sd card reader on

#define CONFIGURATION_H

#define MIN_HARDWARE_ENDSTOP_Y false

#define ENDSTOP_X_MIN_INVERTING true

#define FAN_PIN 4    was -1

#define Z_PROBE_Z_OFFSET 0

#define DUAL_EXTRUDER

#define CONFIGURATION_H

#define HAVE_HEATED_BED 0

#define Z_PROBE_Z_OFFSET 0

#define FEATURE_TWO_ZSTEPPER 1

#define NO_CONTROLLER 0

#define KNOWN_BOARD 1

#define UI_DISPLAY_DOGLCD_CS 27 #define UI_DISPLAY_DOGLCD_A0 25 ?

#define CONFIGURATION_H

#define MULTI_ZENDSTOP_HOMING 0