Search

Hot end not getting any current

by kieranpat · November 2017

#include "pins.h"

motion.h:359: error: expected '}' before 'else'

by Rossini · November 2017

#define NUM_EXTRUDER 1 #define MOTHERBOARD 33 #include "pins.h" // ################## EDIT THESE SETTINGS MANUALLY ################ // ################ END MANUAL SETTINGS ##########

Movement Problem

by goendoels · November 2017

#define NUM_EXTRUDER 1 #define MOTHERBOARD 33 #include "pins.h" // ################## EDIT THESE SETTINGS MANUALLY ################ // ################ END MANUAL SETTINGS ##########

Compiling Problem

by goendoels · November 2017

#define NUM_EXTRUDER 1 #define MOTHERBOARD 33 #include "pins.h" // ################## EDIT THESE SETTINGS MANUALLY ################ // ################ END MANUAL SETTINGS ##########

Delta printer motors uncoordinated

by Cheddy · November 2017

#include "pins.h"

using 2004 RRD smart controller with Smart Ramps

by cinematographer · November 2017

#include "pins.h"

Problems with autoleveling and homing

by Timppa71 · November 2017

#define NUM_EXTRUDER 1#define MOTHERBOARD 33#include "pins.h"

Extruder don't turn anyway (two extruders) and second hotend is dead

by MadCat · October 2017

#include "pins.h"

Two Z min endstops - cannot compile firmware

by tpila1 · October 2017

#include "pins.h"

Delta G32 S2

by novio8 · October 2017

#include "pins.h"

Homes then will move down but not up, delta

by Morris · September 2017

#include "pins.h"

Z-Axis problem with FAST_COREXYZ and two z-axis-endstops.

by Rossini · September 2017

#define NUM_EXTRUDER 1 #define MOTHERBOARD 33 #include "pins.h" // ################## EDIT THESE SETTINGS MANUALLY ################ // ################ END MANUAL SETTINGS ##########