PrisonFeed

Comments

• Good thought, thank you. I did double check that. Here is a brief sample of the G Code. Thank you all again for looking! I am wide open to ANY suggestions that may help.  M107 M104 S200 ; set temperature G28 ; home all axes G1 Z5 F5000 ; lift nozzl…

  in Extruder only extruding in manual mode after fresh install Comment by PrisonFeed December 2017
• I gave up. I finally got it to work by just using ssh and doing it on the pi manually.  It would be nice if this worked from the gui at /#/gsettings/wlan Maybe something that's being worked on? Good luck.

  in Raspberry Pi 3 running 0_85_2_v7 - How do I shut off the silly wireless access point Comment by PrisonFeed July 2017
• Update: I did finally get the Wireless Access Point turned off. However, I still can not make the Pi connect to a wifi. I hoped the problem was the Wireless Access Point being turned off. Apparently this was not the case.  Anyone able to get 0.82.…

  in Raspberry Pi 3 running 0_85_2_v7 - How do I shut off the silly wireless access point Comment by PrisonFeed July 2017