CptAmmogeddon
About
- Username
- CptAmmogeddon
- Joined
- Visits
- 3
- Last Active
- Roles
- Member
Comments
-
So I played around with the sliders, but it still says -273.1/-273.1 and 18.7/-273.1 (sorry, I had a typo in my previous post, the set temp value is also negative). Does that mean, it is a firmware/conmection issue? Since it doesn't even send t…
-
So, after activating the Temp readout and sensing M105, Repetier says: ok T:-273.1 /273.1 B:18.7 /-273.1 @:0 Does that narrow it down?
-
So I have the same problem again, with the same settings that worked last time. The error first occurs during the first layer, sometimes right after starting, sometimes after a few seconds. The last print I tried froze (apparently complete…
-
So I just tried to print the same thing with different settings and it still doesn't work. But trying an older gcode works. So it's officially a gcode/Slicing-problem (im using Cura) I guess... I know this isn't a Cura-forum, but are ther…