Livid

Comments

• hmm, the offset doesn't save. oh well

  in Z endstop offset Comment by Livid February 2018
• what is the z probe bed distance option?

  in Z endstop offset Comment by Livid February 2018
• changed something and it worked, but i forgot which setting i changed and now it's still about 0.75mm off the bed, i just dialed in an offset in the position settings, got a successful first print, if i hit save to eeprom does that save that offset?

  in Z endstop offset Comment by Livid February 2018
• hasn't changed anything unfortunately, i added those settings and change z probe height but it still won;t put the bed at the right height

  in Z endstop offset Comment by Livid February 2018
• aha ok, thanks. i'll throw that in my config.h and see what happens. thanks

  in Z endstop offset Comment by Livid February 2018
• Ok, i'm a noob to repetier-firmware (first 8bit board, i usually use 32bit) how do i do this? i've got the right pin assigned afaik, i'm using an mks gen board, got z probe pin as 24.

  in Z endstop offset Comment by Livid February 2018
• tried that, it didn't change anything unfortunately, it won't home properly

  in Z endstop offset Comment by Livid February 2018