anjoze
About
- Username
- anjoze
- Joined
- Visits
- 1
- Last Active
- Roles
- Member
Comments
-
I've found that if I press the Z button it will not go more than -0.01 but if I send a G1 Z-(value) it will go the that negative value!!! Shouldn't be the same?!
-
Another interesting thing... when I send G30 the extruder goes up and then I have the error like in the attachment. Is it normal to go UP? Shouldn't be Down?
-
I've tried to change some settings without success. As described on your instructions I've changed this: #define Z_PROBE_ON_HIGH true (Had to change to 0 again because when I make G30 P0 it starts to go up and then gives error) #define Z_PROBE_SWI…
-
I had ALWAYS_CHECK_ENDSTOPS 1 I've changed to 0 and upload the firmware Tried but didn't worked. Then I've changed EEPROM_MODE to 2 to force overwrite settings. Tried again but didn't work Maximum I can go is -0.01 Here is a link with mi Configura…
-
Thanks for your reply. I've tried with no success. The minimum Z height I can go is -0.01