fischp

Comments

• Great, that worked!  I now get good small part prints. Thanks!

  in 5mm calibration, smallest cubes not forming correctly Comment by fischp April 2018
• Hi again, I see "slow down if print time is below X seconds." in the interface for filaments, however, I don't see something that says, slow down for small parts.  The above probably helps me with the calibration pyramid, but it wouldn't do any good…

  in 5mm calibration, smallest cubes not forming correctly Comment by fischp April 2018
• Thank you, I'll look for that and give it a try.

  in 5mm calibration, smallest cubes not forming correctly Comment by fischp April 2018